8 Essential Tips on Plumbing Leaks

No house is deemed complete without an efficient plumbing system. However, just like any other man-made systems, your house plumbing system might become faulty with time. Some of the plumbing problems do not need an expert to be fixed, while others like those associated with complications in the heating systems need to be handled by a competent plumber. You must not know everything about plumbing, but it is imperative to equip yourself with the most basic tips, especially those which have to do with plumbing leaks, if you are going to be in a position to take good care of the plumbing systems in your home and avoid unnecessary leakages. Here are eight essential tips on leakages.

Always Enclose Your Pipes In Heat

The exterior piping is always quite important. When cold-water pipes come into contact with the outer part of the building, especially if the water is not in use and the temperatures are too low, there is a high likelihood of the pipes freezing. Water may only not freeze if it is in motion, hence it is always advisable to leave all faucets open any time you are away for a long time. Although, insulating your pipes might be your ultimate solution.

Do A Regular Quick Check On Your Piping

It is never a hard thing to spot an anomaly in the plumbing system. Doing a quick check on any visible water pipes regularly, might help you to curb any major leakage before it happens. You wouldn’t want to be surprised by a paddle of water, from a leakage that could have easily been averted, soaking and damaging all your valuable stuff in the basement. You may not know what the tell-tale signs of a faulty piping system are, but if you notice buckling, rust or some water drops, that will be enough to raise an alarm on a faulty plumbing system.

Don’t Over-stuff Your Sink

If you have so much clatter stuffed under your sink, you may not notice when a leakage begins. You are safer taking a look regularly just to make sure that there are no drops from a water leakage.

Ensure Your Radiators Have A Good Level And An Open Valve

Checking the pitch of the radiator should be the first thing you do. Ensure that it is always pitched backwards facing the steam source. This makes the water drains back into the boiler after condensing.

Set Back The Spigot valve

Sometimes, installation of a frost-free hose bib is advisable, especially when the pipe passes through a cement foundation. The hose bib makes it possible for one to shut off the water near the inside of a home making prevention of freezing possible.

A Leaky Water Heater Is The Last Thing You Want

If the lining of your water heater wears off and water starts dripping from the base, know that your heater is almost dead. If too much water is leaking, give your manufacturer a call and supply them with the model number. Lady luck might just smile right and you might find that the heater is still covered by the warranty. If it can’t be changed, then at least a pan should be installed under it.

The Trap Leak May Be Traced Back To The Wall

Any time you have a leak; it might mostly be on the back side, where the pipe connects to the wall. This might need dismantling of the drain work. Sometimes you can even tighten it using your own hands to make the leakage to stop.

Replace The Gasket Instead Of Replacing It

Whenever any water is leaking from the shower spout, the most likely culprit is a faulty washer or a faulty seat in its body. If you have isolation valves to separate water to the area, it shouldn’t be hard to fix. Just isolate the water to the shower, dismantle the handles and pull out the stem which has the washer and do a replacement or a re-installation then watch how it behaves.

Conclusion

If you think you don’t know the cause of a leakage in your house and you have no idea what needs to be done, it is always important to have the number of a trusted plumbing expert on speed dial. Just make that call and seek professional intervention.